Connect to the Range
1. Feed the electric cable wires through the flexible metal conduit.
NOTE: Allow enough slack to easily attach the wires to the terminal block.
2. Remove the screws fastening the back panel to the cabinet of the range. Lift
off the back panel to access the electrical terminal block located in the bottom
right-hand corner.
3. Install a UL listed strain relief (not provided) to the conduit opening in the back
panel, and then completely tighten the nut.
4. With one person holding the back panel, thread the end of the conduit through
the strain relief.
20
a
Conduit
Opening
a
a
b
a
UL Listed Strain Relief
b
Back Panel
c
Conduit
c