Baxtran STN300 Manual De Usuario página 19

STN
High resolu on digital crane scale
6-2. INDICATORS
MESSAGE
6-3. MESSAGE
MESSAGE
- - - - -
SEtUP
bAt99
End
oFF
ouEr
7. OPERATIONS
7-1. POWER ON/OFF
Press
for 1s to power-on scale. Scale perform initialization and power-on test,
1000
then capacity
shows, battery life percentage
auto zero.
>
For information about Auto-Zero, refer to Scale Configuration in Technical Manual.
Press for 1s to power-off scale. Battery life percentage
cut off power.
>
When 3 batteries voltage is lower than 3.2V, scale will auto power-off itself. Please replace the dead bat-
teries with new ones.
7-2. ZERO
Press for 1s to zero.
If load is in motion, or tared, or out of Manual-Zero Range,
>
For information about Manual-Zero Range, refer to Scale Configuration in Technical Manual.
7-3. TARE IN/OUT
In gross mode, press
If load is in motion, or negative, or out of Tare Range,
Tare will reduce the apparent overload range of scale. For example, if a 5000*2kg scale has a 1000kg container
as its tare, the scale will overload at a new weight of 4018kg (5000 – 1000 + additional 9 divisions).
In net mode, press
Manual de usuario | Manuel d'usager | User's guide
NAME
S Stable
Z Zero
T Tared
H Hold
lb
LB
KG kg
UN UN
STAND FOR
-
SETUP
BATTERY
END
OFF
OVERLOAD
ERROR
Err
Z shows.
T
to tare in. shows.
T
to tare out. disappears.
NOTE
Shown when weight is stable
Shown when weight is at zero
Shown when scale is tared
Shown when scale is locked
Shown when unit is lb
Shown when unit is kg
Shown when unit is User Unit
NOTE
Detect weight
In Idle Mode
User Setup Menu
Battery life percentage
Save and exit
Power off
Overloading
Invalid operation
bAt99
shows, weight detection
bAt99
shows, off message
Err shows.
Err
shows.
ENG
FR ES
8.8.8.8.8.
shows twice,
- - - - -
shows and then
oFF
shows, and then
19