Special Accessories; Set Of Turn Plates, Mechanical 1 987 009 A00N; Set Of Turn Plates, Electrical 1 987 009 A07N; Set Of Spoiler Adapters 1 987 009 A03N - Nussbaum WA 950 Instrucciones De Montaje

4.

Special accessories

4.1

Set of turn plates, mechanical 1 987 009 A00N

Both turn plates are set up for the maximum steering deflection.
This can be read off at the turning angle gauges A) at the turn
plates (Fig. 31).
Fig. 31: Turn plates, mechanical
4.2

Set of turn plates, electrical 1 987 009 A07N

Place both turn plates on the rack in the proper position. Connect
the recorder to the front sensors by means of the connecting
cables A) (Fig. 32). That makes it possible to determine the
maximum steering deflection by means of the sensors.
Fig. 32: Turn plates, electrical on the rack
30
4.3

Set of spoiler adapters 1 987 009 A03N

Scope of supply:
- 2 x spoiler adapters
- 1 x Allen key 4mm D) (Fig. 34)
Installation:
1. Remove the two Allen screws of the full floating axle A) (Fig. 33)
from the back of the clamp.
Fig. 33: Rear of clamp
2. Attach the full floating axle to the spoiler adapter with the two
Allen screws B) (Fig. 34).
Fig. 34: Installation of spoiler adapter
3. The spoiler adapter can be attached to the shaft of the clamp
(see Fig. 35) with the locking screws C) at the side (Fig. 34).
If the spoiler adapter function is not required, this can also be
installed in the middle (see Fig. 36).
Fig. 35: Spoiler adapter on the clamp, self-centering functioning
08.12.08 1 689 978 435N