Adapter Kit Smart 3-Hole 1 987 009 A20N; Infrared Remote Control 1 987 009 A13N; Program Upgrades - Nussbaum WA 950 Instrucciones De Montaje

4.10

Adapter kit SMART 3-hole 1 987 009 A20N

Scope of supply:
- 4 x adapter disks for 3-hole rims
- 8 x screws M5x10
Installation:
There are two threaded holes at the back of the clamps. Insert an
M5x10 screw into each of them and do them up tight. Put the
adapter in place, with the flat side toward the screws. Turn the
adapter until it comes up against the stop so that it is held by the
screw heads.
Fig. 46: Adapter kit SMART 3-hole 1 987 009 A20N
4.11

Infrared remote control 1 987 009 A13N

There is a cutout in the lower front door for the infrared receiver
LED.
- Attach the PCB in the inner part of the door of the trolley with
the screws that are there.
- Lay the cable in the inside area at the back of the SmartCard
reader.
Ensure that the cable is not damaged by the door or other
moving parts.
- Plug the cable with the adapter into the 25-pin socket at the
back of the SmartCard reader (Fig. 49).
Fig. 47: Infrared remote control
1 689 978 435N 08.12.08
4.12

Program upgrades

Insert the SmartCard that was supplied into slot „B" of the USB
interface (Fig. 47). When inserting the card, ensure that the
contacts go first into the reader. The golden contacts are at the
front on the right.
Fig. 48: SmartCard
Once the card has been inserted into the reader, you can select
the relevant update function within the program. The data is then
transmitted to the system.
Fig. 49: SmartCard reader
Keep all the SmartCards in a safe place. They may be
required again during servicing work.
33