Battery Power; Radio Operation - Roadstar TRA-2235 Manual De Instrucciones

1 English
LOCATION OF CONTROLS
1. SPEAKER
2. EARPHONE OUTPUT
3. DIAL SCALE
4. TELESCOPIC ANTENNA
5. BATTERY COMPARTMENT
6. AC CABLE
7. TUNING KNOB
8. VOLUME CONTROL / ON - OFF SWITCH
POWER SOURCES
AC POWER:
You can power your portable radio by plugging the AC power cord into the AC plug (6)
at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
Make sure that the AC power cord is fully inserted into the appliance.

BATTERY POWER:

To use the radio with batteries, disconnect the AC power cord and insert 4 × "LR6"
batteries into the compartment (5).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your radio.

RADIO OPERATION

1. Turn the "ON - OFF SWITCH" (8) clockwise to switch the unit ON.
2. Adjust radio frequency to your desired station by using the tuning control (7).
3. Adjust the volume control (8) to the desired level.
4. Turn the "ON - OFF SWITCH" (8) counter clockwise to switch the unit OFF.
Note: For a better reception, reorient the antenna (4).