Service And Maintenance - Ega Master 55835 Manual De Instrucciones

longer tool life, the pressure of the air supplied to these tools should not exceed the rated PSI at the
tool when the tool is running.
Using a higher than rated pressure will cause faster wear and drastically shorten the tool's life.
A higher air pressure can also cause an unsafe condition. The inside diameter of the hose should
be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter
should be 3/8" I.D. and fittings should have the same inside dimensions. The use of air line
lubricators and air line filters is recommended to prevent water in the line that can damage the tool.
Drain the air tank daily. Clean the air inlet filter screen on at least a weekly schedule to remove
accumulated dirt or other matter that can restrict air flow.
It is strongly recommended that a regular service programme for all air powered tooling be
adopted and managed, as reqularly maintained air tools ensure a long life cycle, optimal power and
reduced operating expenses. Repairs of air tools should be carried out by trained specialists and
authorized service dealers. For this reason, we strictly advise against attempting to repair without
this support. Pour a liberal amount of air tool oil in air inlet. If tool remains jammed, it should be
serviced by an authorized service Center. If operation cannot be restored, tool should be checked
by the fabricant or an authorized service center.
12

SERVICE AND MAINTENANCE