Service And Maintenance - Ega Master 79919 Manual De Instrucciones

• Replace damaged parts immediately.
• When working on brittle material make sure that you are protected against harmful
splinters.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Use only machine tools, accessories and consumables, which are recommended by the
manufacturer. Make sure choosing the correct size and the correct type. Use only accessories,
which are in proper condition and do not touch them during operation.
CAUTION – Injury due to carelessness!
If the machine is fixed to suspension equipment make sure that it is secure. Never
hang the machine onto the supply line.
Separate the machine form any external energy source before changing the
·
machine tool or an accessory.
· Avoid direct contact with the machine tool during and after use as it can be hot or
sharp.
· Wear protective gloves when changing a tool or an accessory!
Notice: Defective/ inappropriate gloves can lead to injury. Only wear proper hand protection,
adapted to the work place requirements.
WARNING – Explosion hazard!
When operating the machine in areas exposed to explosion hazards, use only
accessories, respectively devices, which are ATEX approved and specified.
SAFETY INSTRUCTIONS FOR PREVENTION OF TRANSPORT HAZARDS
ATTENTION – Improper Transport, danger of life due to parts falling down!
Damage of the machine!
· Separate the machine form any external energy source before transportation.
Check that the machine is undamaged and in proper condition.
· Never carry the machine at the supply line.
Wear worker's protective shoes!
Basic Safety Instructions:
WARNING – Maintenance and repair work on hydraulic equipment.
Hydraulic can cause severe injury. Observe legal regulations. Take precautions for
persons and environment.

SERVICE AND MAINTENANCE

39