Security Instructions - Ega Master 55835 Manual De Instrucciones

• Before using this tool, all operators must be fully trained in its use and be aware of these
safety rules.
• Do not exceed the maximum working air pressure of 90 PSI/6.2 bar .
• Use personal safety equipment.
• Use only compressed air at the recommended conditions.
• If the tool appears to malfunction remove from use immediately and arrange for service and
repair If the tool is used with a balancer or other support device ensure that it is securely fixed.
• Always keep hands away from the working attachment fitted to the tool.
• The tool is not electrically insulated. Never use the tool if there is any chance of it coming
into contact with live electricity.
• When using the tool always adopt a firm footing and/ or position and grip the tool firmly to
be able to counteract any forces or reaction forces that may be generated whilst using the tool.
• Use only correct spare parts. Do not improvise or make temporary repairs.
• Do not lock tape, wire, etc. the on/off valve in the run position. The trigger/lever etc. must
always be free to return to the 'off' position when it is released.
• Always shut off the air supply to the tool, and depress the trigger/lever etc. to exhaust air
from the feed hose before fitting, adjusting or removing the working attachment.
• Check hose and fittings regularly for wear. Replace if necessary. Do not carry the tool by its
hose and always ensure the hand is well away from the on/ off control when carrying the tool with
the air supply connected.
• Take care against entanglement of moving parts of the tool with clothing, ties, hair, cleaning
rags, etc. This will cause the body to be drawn towards the tool and can be very dangerous.
• Do not install the tool unless an easily accessible and easily operable on/ off valve is
incorporated in the air supply.
• Take care that the tool exhaust air does not cause a problem or blows on another person.
• Never lay a tool down unless the working attachment has stopped moving.
• Always ensure that the reverse button is in the selected position before starting the tool.
• Do not use sockets with excessive wear to the input and output drives.
• Periodically check the square drive on the impact wrench.
• Make sure the socket, extension is firmly fixed to the tool.
• When loosening fasteners first ensure that there is sufficient clearance behind the tool
to avoid hand entrapment. The tool will move away from the threaded joint as the nut/bolt is
loosened and rides up in the thread moving the tool with it.
• It is expected that users will adopt safe working practices and observe all relevant legal
requirements when installing, using or maintaining the tool.
• The tool is designed to be used only for the purpose of driving, tightening and loosening of
threaded fasteners, usually nuts and bolts, when fitted with a suitable drive socket.
• It is allowed to use impact-rated extension bars, universal joints and socket adapters
between the square output drive of the ratchet wrench and the female square drive of the socket.
• Do not use the tool for any other purpose than that specified without consulting the
manufacturer or the manufacturer's authorized supplier as this may be dangerous.
• Never use the tool as a hammer to dislodge or straighten cross threaded fasteners.
• Never attempt to modify the tool for other uses.

SECURITY INSTRUCTIONS:

PROPER USE OF THE TOOL
9