Dmx-Protocol; Addressing; Remotely Controllable Functions; Lamp - Futurelight CC-200 Manual Del Usuario

4.1.4 Channel 4 - dimmer
0
1-126
127
128-192
193-254
255

4.2 DMX-protocol

DMX
Channel
Function
The Control Board on the top side of the CC-200 allows you to assign the DMX fixture address, which is
defined as the first channel from which the CC-200 will respond to the controller.
If you set, for example, the address to channel 5, the CC-200 will use the channel 5 to 8 for control.
Please, be sure that you don't have any overlapping channels in order to control each CC-200 correctly and
independently from any other fixture on the DMX data link.
If two, three or more CC-200 are addressed similarly, they will work similarly.
For address setting follow this procedure:
1. Switch on the CC-200 and wait until the fixture reset has finished ("rSt" is flashing at the display).
2. Press the [Mode] key in order to access the main menu. Browse through the menu by pressing the [Up]
and [Down] keys until the display shows "A001". Confirm by pressing [Enter] key and the letter "A" will
flash.
3. Use the [Up] and [Down] keys to select the desired address.
4. Confirm by pressing [Enter] or [Mode] to cancel.
Controlling:
After having addressed all CC-200 , you may now start operating these via your lighting controller.
Note:
After switching on, the CC-200 will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will start to flash "A001" with actually set address.
This situation can occurr if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the CC-200
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

6.1 Lamp

The CC-200 is to be operated with a MSD 230 V/250 W GY-9.5 or MSD 230 V/200 W GY-9.5 lamp.
A relay inside of the CC-200 allows you to switch on and off the lamp via the Control Board on the top side or
via your controller without affecting the rest of the lighting.

6.2 Switching on and off the lamp via the Control Board

1. Switch on the CC-200 and wait until the fixture reset has finished.
closed, Light is full Off
smooth dimming from black to full open
Light is full On - sharp beam
smooth dimming from full open to black
smooth dimming from black to frost (wash) light
full open - frost (wash) light
1
Colour-wheel Effect-wheel

5. Addressing

6. Remotely controllable functions

2 3
Fan, Shutter, Strobe
31
4
Dimmer