Workpiece Support - Bosch 4405 Instrucciones De Funcionamiento Y Seguridad

Basic Saw Operations
Long workpieces have a tendency
! WARNING
to tip over unless clamped down
and properly supported from underneath.
Clamps
Workpiece Clamp - This clamp easily secures a
workpiece in any of three (3) clamp holes behind the
fence (Figure 20).
• Insert clamp post into clamp hole.
• Loosen wing nut and adjust arm to proper height,
and securely tighten wing nut.
• Rotate screw knob of the clamp clockwise to
tighten, counter-clockwise to loosen.
• Move the head assembly to check clearance
with clamp.

Workpiece Support

!
Support workpiece with hand outside No Hands
Zone. Do not try to cut short pieces that cannot be
clamped and cause your hand to be in the No Hands
Zone.
Workpiece
Clamp
Clamp
Hole
Screw
Rod
Conventional Clamps and other hold down devices
can be used to hold the workpiece firmly against the
table and the fence.
20.
There may be extreme compound
WARNING
cuts where clamp cannot be used.
Figure 20. Workpiece Clamp
Clamp
Holes