Assembly; Tools Needed For Assembly And Alignment; Unpacking And Checking Contents - Bosch 4405 Instrucciones De Funcionamiento Y Seguridad

Tools Needed For Assembly And Alignment

Phillips Screwdriver
Combination Square
Should be no Gap or Overlap
when Square is Flipped Over in
Dotted Position
Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible
injury.

Unpacking And Checking Contents

Model 4405 Slide Compound Miter Saw is shipped
complete in one box.
1. Separate all parts from packing materials and
check each one with the "Table of Loose Parts" to
make sure all items are accounted for before dis-
carding any packing material.
2. Table of Loose Parts: (See pages 8 and 9)
Screw Clamp
Dust Elbow/Dust Bag
Miter Lock Knob

Assembly

Blade Wrench (supplied), hex on
other side of phillips.
Combination Square Must be True
Draw Light
Line on Board
Along this Edge
Call 1-877-BOSCH99; if you need assistance.
Straight Edge of
Board 3/4" Thick
This Edge Must be
Perfectly Straight
If any parts are missing, do not
! WARNING
plug in power cord or turn the
switch on until the missing parts are obtained and
are installed correctly. Call 1-877-BOSCH99 to
obtain missing parts.
Before moving the saw: Lock the
! WARNING
miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly
completely toward you and tighten the slide rail lock
knob. Lock head assembly in the down position.
Never carry the tool by the slide rails, this may
cause blade misalignment.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connec-
tions could cause a fire.
10.