2610051914.qxp_GCM18V-08 6/24/19 1:56 PM Page 30
Preparing for Saw Operations
▶ Workpiece Support
▼ LONG WORKPIECE SUPPORT
clamped down and properly supported from
underneath.
extension or as additional support.
Operating Sliding Base Extensions –
▼ ADDITIONAL WORKPIECE SUPPORT
Blocks –
workpiece.
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
Long workpieces have a
tendency to tip over unless
Do not use another person as
a substitute for a table
Always adjust the sliding
base extension to support
Be aware of the path of the
saw blade. Make a dry run
Fig. 32
Base Extension
Fig. 33
Two 2x4 Pieces
3-7/16"
30
Base Extension
Clamping Screw