Miter Cut; Bevel Cut - Bosch 4405 Instrucciones De Funcionamiento Y Seguridad

Miter Cut

• A miter cut is made at 0° bevel and any miter
angle in the range from 50° left to 60° right.
• The miter scale is cast-in on the table for easy
reading.
• Positive detents have been provided for fast and
accurate mitering at 0°, 15°, 22.5°, and 45° left
and right and 60° right.
• There are crown molding detents (left and right)
at 31.6° (see Cutting Crown Molding for more
information page 28).
• For off detent settings, use the detent override to
lock out the detent.
• A miter cut can be made as either a chop cut or
a slide cut depending on the width of the work-
piece.
Follow these instructions for making your
miter cut:
1. Loosen miter lock knob. Lift miter detent trigger
and move the saw to the desired angle, using
either the detents or the miter scale. Tighten
miter lock knob (Figure 28).
2. Properly position workpiece. Make sure work
piece is clamped firmly against the table and the
fence.

Bevel Cut

• A bevel cut is made at 0° miter and any bevel
angle in the range of 0° to 45°.
• There are factory set bevel stops at 0° and 45°. (See
Adjustment section if adjustments are required.)
• The bevel scale faces the operator for easy reading.
Saw Operations
25.
Use clamping position that does
!
WARNING
not interfere with operation. Before
switching on, lower head assembly to make sure
clamp clears guard and head assembly.
3. Follow procedures for either chop cut or slide
cut (see page 24).
4. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
Workpiece
Clamp
Detents
Figure 28. Miter Cut
• There is a positive crown molding bevel stop at
33.9°. Disengage this stop unless using. (See
Cutting Crown Molding for details.)
• A bevel cut can be made as either a chop cut or
a slide cut depending on the width of the work-
piece.
• Use sliding fence and work supports as appropri-
ate. (See Sliding Base/Fence Extension page 23.)
Workpiece
Miter Scale Miter Lock
Knob