Dometic PERFECTVIEW CAM 360 Instrucciones De Montaje página 34

Video system settings
The following materials are required to calibrate the camera angles:
• Calibration set (refer tochapter "Accessories" on page 17):
– 4 calibration mats with calibration pattern (2.0 x 1.6 m)
• 5 measuring tapes with a minimum length of 10 m
• Adhesive tape
Key for fig. k, page 10
No. in
fig. k,
Description of the dimensions
page 10
a, b, c, d Distance to vehicle 20 - 25 cm (depending on vehicle height)
L Length of the vehicle plus distance to the front and rear calibration mats
W Width of the vehicle plus distance to the right and left calibration mats
O Offset between front calibration mat and side calibrating mats (must be
identical on both sides)
➤ Position the four calibration mats as shown in fig. k, page 10 and secure them
with adhesive tape.
➤ Position the measure tapes as shown in fig. k, page 10.
➤ Turn on the ignition to activate the system.
➤ Press the
button on the remote control.
➤ Select "CALIBRATION".
➤ Enter the password "654321".
34
CAM360
EN