CAM360
• Attach the cables securely in the vehicles to prevent tripping hazards. This can be
performed by using cable binders, insulating tape or gluing in place with adhe-
sives.
• Protect every through-hole made in the bodywork against water penetration,
e.g. by using a cable with a sealant and by spraying the cable and the cable
sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all installa-
tion work on the camera and have laid the required cable lengths.
8
Installing the video system
!
CAUTION!
Select a location for the camera and attach it firmly enough so that it can-
not under any circumstances fall off and injure bystanders (for example,
by being knocked off by branches brushing over the roof of the vehicle).
A
NOTICE! Risk of damage!
• The system may only be permanently installed after a successful test
calibration.
• Before drilling or screwing, make sure that the respective cable
lengths are long enough.
I
NOTE
If installing the camera alters the vehicle size specified in the vehicle doc-
uments, your vehicle must be inspected by the appropriate authorities.
This authority must note any such changes your vehicle documents.
EN
Installing the video system
21