Waeco PerfectView M9LQ Instrucciones De Montaje página 36

Installing the LCD monitor
Connecting control cables for additional cameras
The control cables are used as a signal cable for the activation of a side camera when the
indicator is flashing, for example.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the
following control cable to a positive cable of the indicator:
– blue cable (12) for CAMERA RIGHT ( RIGHT video source) e.g. to the right
indicator cable
– white cable (13) for CAMERA LEFT ( LEFT video source) e.g. to the left indicator
cable
I
NOTE
If voltage is present in the control cable, the respective CAMERA RIGHT video
input or CAMERA LEFT video input is activated.
Up to fours cameras can be connected. These can be displayed individually through
the control cable. For example, the monitor can display a four split screen by default and
individual screens with control signal.
Connecting the cameras
➤ Connect the CAMERA BACK socket (5) of the connection cable with the plug of the
BACK video source (e.g. reversing camera).
➤ Connect the CAMERA RIGHT socket (6) of the connection cable with the plug of the
RIGHT video source (e.g. side camera).
➤ Connect the CAMERA LEFT socket (7) of the connection cable with the plug of the
LEFT video source (e.g. side camera).
➤ Connect the CAMERA FRONT socket (8) of the connection cable with the plug of the
FRONT video source (e.g. front camera).
I
NOTE
Observe the power consumption of the video system. The cameras are
equipped with heaters. A maximum current of 3 A can flow (cameras in heating
mode). Use a disconnector switch for direct connection to the battery. This
allows you to disconnect the video system from the battery easily if you are no
longer using the vehicle.
Connecting the split screen control cable
➤ Connect the SPLIT control cable to a 10 – 32 V voltage signal which will activate the
split screen.
The split screen shows two cameras, which can be set in the "Trigger setup" menu at
"Split screen".
36
PerfectView M9LQ
EN