Using The Lcd Monitor; Switching On The Monitor; Using Menus - Waeco PerfectView M9LQ Instrucciones De Montaje

PerfectView M9LQ
8

Using the LCD monitor

I
NOTE
You can find a detailed operating manual on our website at www.dometic.com.
8.1

Switching on the monitor

➤ If the monitor is switched off, press the P button (fig. 0 3, page 6) to switch the
monitor on.
✓ The button lights up green.
✓ Depending on how the monitor is connected, the image appears:
– directly connected to the battery: the previous screen configuration selected
– connected to the ignition: the screen configuration set in the "System setup" sub-
menu, "Power on" parameter.
8.2 Switching off the monitor
➤ Press the P button (fig. 0 3, page 6) to switch off the monitor.
✓ The button lights up red.
✓ The picture disappears.
8.3 Set the language
The language in the menu is English by default. You can set the menu language as
follows (fig. 0, page 6):
➤ Press the "M" button (7) to open the main menu.
➤ Press the "S" button (8) until "OSD setup" is highlighted in green.
➤ Press the "–" button (4) or the "+" button (5) to open the sub-menu.
➤ Press the "S" button (8) until "Language" is highlighted in green.
➤ Press the "–" button (4) or the "+" (5) until the menu in the required language appears.
8.4

Using menus

To set the monitor with a menu to suit your requirements, proceed as follows (fig. 0,
page 6):
Selecting menu items
➤ Press the "M" button (7) to open the main menu.
✓ The sub-menus to be set are displayed (chapter "Main menu" on page 31).
➤ Press the "S" button (8) to select the individual sub-menus.
➤ Press the "–" button (4) or the "+" button (5) to open the required sub-menu.
✓ The parameters to be set appear.
EN
Using the LCD monitor
37