Metrix ScopiX IV OX 9062 Manual De Instrucciones página 92

ARM[:SEQuence{[3]|4}]
:SOURce
AUTOSet:EXEcute
CALCulate:MATH
{[1] |2|3|4}[:EXPRession]
[:DEFine]
CALCulate:MATH
{[1] |2|3|4}[:EXPRession]
:DELete
CALCulate:TRANsform
:FREQuency[:STATe]
CALCulate:TRANsform
:FREQuency:WINDow
DEVice:MODe
DISPlay: BRIGhtness
DISPlay[:WINDow]:CURSor
:REFerence
(Command/Query)
The ARM:SOUR <INTernal{1|2|3|4}> command determines the auxiliary trigger source of the
instrument.
INTernal{1|2|3|4} corresponds to the trigger source (1, 2, 3, 4 channels) of the instrument on
SCOPIX and SCOPIX BUS.
To the question ARM:SOUR?, the instrument returns the used trigger auxiliary source.
(Command)
The AUTOS:EXE command starts an autoset on each active channel.
(Command/Query)
The CALC:MATH{[1]|2|3|4} <(function)> command defines and activates the mathematical
function of the selected signal.
<function> is the definition of the mathematical function.
(ch1-ch2) subtracts the channel 1 from channel 2.
To the question CALC:MATH{[1]|2|3|4}?, the instrument returns the mathematical function of
the selected signal.
(Command)
The CALC:MATH{[1]|2|3|4}:DEL command deletes the mathematical function of the selected
signal.
(Command/Query)
The CALC:TRAN:FREQ <1|0|ON|OFF> command activates the FFT calculation.
To the question CALC:TRAN:FREQ?, the instrument returns the activation status of the FFT
calculation.
(Command/Query)
CALC:TRAN:FREQ:WIND <RECTangular|HAMMing|HANNing|BLACkman|FLATtop>
window used for the FFT calculation.
To the question CALC:TRAN:FREQ:WIND?, the instrument returns the type of window used
for the FFT calculation.
(Command/Query)
The DEV:MOD <SCOPe|ANALYSer|LOGger|MULTimeter> command selects the principal
mode of the instrument.
To the question DEV:MOD?, the instrument returns the mode in which it has been configured.
(Command/Query)
The DISP:BRIG <brightness> command sets the backlight intensity of the screen.
<backlight> is a value in format <NRf> without unit, in the range [0.0 1.0]
To the question DISP:BRIG?, the instrument returns the backlight level of the screen.
(Command/Query)
The DISP:CURS:REF <INT{1|2|3|4}> command selects the reference for the automatic and
manual measurements.
To the question DISP:CURS:REF?, the instrument returns the signal used as reference.
92
Programación