Shark Rotator Lift-Away Pet ZU570 Serie Manual Del Propietário página 7

AVAILABLE ACCESSORIES
Duster Crevice Tool
A
Two cleaning tools in one. The crevice tool
gives you extended cleaning reach for small
spaces, while the soft dusting brush cleans
a multitude of surfaces.
Hair Removal Multi-Tool
B
A single convertible tool for cleaning tough
pet messes two ways: first, a rubber bristle
brush for cleaning stubborn hair from
carpeted areas. Then remove the bristles
to reveal an upholstery tool perfect for
cleaning couches and bedding.
Wide Upholstery Tool
C
Wide cleaning path helps remove pet hair,
dust, and large debris from mattresses,
couches, curtains, lampshades, and other
delicate upholstered surfaces.
Pet Power Brush
D
Designed to remove pet hair and ground-in
dirt from carpeted stairs and upholstery.
Under-Appliance Wand
E
Clean under and behind hard-to-move
appliances and furniture with this adjustable
36" tool. Flip the extension piece over to
clean the underside of appliances.
NOTE: Not all accessories come with all units. Please see the enclosed Quick Start Guide for your unit's
configuration. To order additional accessories, visit sharkaccessories.com.
s h a r kc l e a n . c o m
Vacuum is not picking up debris. No suction or light suction.
A
• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinserting in the vacuum.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found.
(Refer to Checking for Blockages section for more information.)
• If any hair, string, or carpet fibers are wrapped around the brushroll, extend cleaning time to
allow the self-cleaning brushroll to remove them.
– If some hair or fibers remain wrapped around brushroll after continued use, remove the
floor nozzle cover and carefully cut debris with scissors and remove from brushroll. See
B
Cleaning the Brushroll section for more information.
Vacuum lifts area rugs.
• Make sure Power/Surface switch is set to Hard Floor (setting I).
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn
edges.
• To minimize suction, slide Suction Control to MIN.
Brushroll does not spin.
• If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum,
and turn on power.
C
• With the power on, recline the handle, which will automatically turn on the brushroll.
• Ensure that the Power/Surface switch is set to Carpet (position II) for brushroll to spin.
Vacuum turns off on its own or indicator light flashes red.
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
thermostat will automatically turn the suction motor off. Perform the following steps to restart
the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning the Filters).
3. Check for blockages in hose, accessories, and inlet openings.
D
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and turn it on with the Power/Surface switch.
E
For all other issues, please call Customer Service 1-800-798-7398.
TROUBLESHOOTING
s h a r kc l e a n . c o m