Display; Mode; Brewing Temperature; Coffee / Water Ratio - Beem 03597 Manual De Instrucciones

33

Display

Roughly 30 seconds after the last button was pressed, the indication shown on the display (2)
switches to the time, unless the device is in operation. Press any button to return to the last
active display.
After around 10 minutes, the display switches off completely. Press any button to return to the
last active display.

Mode

The device has two different modes: "Auto" and "Manual". In "Auto" mode, the brewing
temperature and the ratio of coffee powder to water is preset to 93 °C and 1:15. In "Manual"
mode, you can set these variables individually (see the following "Brewing Temperature" and
"Coffee / Water Ratio" sections). "Manual" mode is preset when the device is switched on.
1. Turn the rotary knob (3) to the position Brew Mode A / M.
2. Use the
permanently on the display (2) and is automatically active.
The Brew Mode A / M program is additionally used for weighing the coffee powder.

Brewing Temperature

The temperature of the water which is poured over the coffee powder to brew it is preset to
93 °C in "Auto" mode. In "Manual" mode you can in turn set it individually. You can choose a
temperature of between 80 and 98 °C.
1. Turn the rotary knob (3) to the position Temp.
2. Use the
temperature is shown on the display (2) and is automatically active.

Coffee / Water Ratio

The ratio between coffee powder and water is preset to 1:15 in "Auto" mode. In "Manual"
mode you can set it individually. You can choose an option of between 1:10 and 1:20. The
second fi gure represents the multiple of the amount of water relative to a quantity of coffee.
Example: With a ratio of 1:15 and a coffee quantity of 15 g, 15 times the amount of water, so in
this case 225 ml of water, is used for brewing.
Bear in mind when selecting the ratio and the quantity of coffee powder that the
quantity of the brewed coffee must not exceed 750 ml!
1. Turn the rotary knob (3) to the position C / W Ratio.
2. Use the
on the display and is automatically active.
03597_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 33 03597_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 33
and buttons (5) to set the mode you want. The selected mode is shown
and buttons (5) to set the temperature you want. The selected
and buttons (5) to set the option you want. The selected ratio is shown
EN
18.12.2018 10:50:06 18.12.2018 10:50:06