Beper BF.551 Manual De Instrucciones página 17

EN
Microwave oven Use instructions
ADVICE FOR REHEATING FOOD
Foods must be defrosted before reheating.
Remove the packages and containers with metal parts.
Choose the correct function based on weight, temperature and type of food.
Mix the food occasionally during heating.
Cover foods with microwavable plastic wrap/cling film to keep moisture in as well as to keep the oven clean.
DESCRIPTION Fig.1
1 – Control panel
1A – Function setting knob
1B – Timer knob
2 – Door opening button
3 – Rotating axis
4 – Rotating ring
5 – Glass plate
6 – Door with viewing window
7 – Door interlock
8 – Vents
9 – Cord supply
USE INSTRUCTION
INSTALLATION OF THE MICROWAVE OVEN
Remove all the packaging and accessories. Examine the oven to make sure the inside part or the door are not
damaged. Do not install the oven if it is damaged.
Place the microwave oven on a flat surface with enough space for ventilation inlet and outlet.
A minimum space of 7.5 cm is required between the microwave oven and adjacent walls. One side must be
open.Fig.2
Allow a minimum clearance of 30 cm above the oven.
Blocking the entrance and/or output can damage the oven.
Do not remove the feet located on the bottom of the oven.
Place the oven as far as possible from the radio or television. The operation of the microwave oven can cause
interference to radio or television.
Connect the microwave oven to the electrical outlet, make sure the voltage is equal to that indicated on the label
of the oven.
!ATTENTION!
Do not install the microwave oven on a stove or other appliances that produce heat. If the unit is installed
on or near a heat source, the oven could be damaged and make void the warranty.
INSTALLATION OF TURNTABLE PLATE Fig.4
Place the rotating ring on the rotating axis inside the microwave oven (cooking space).
Place the glass plate on the rotating ring in the way that the former fits well on the rotating axis.
It is very important that the glass plate is placed properly to ensure correct rotation of the food while cooking.
Never place the glass plate upside down, as it will not fit properly onto the rotating axis.
The glass plate, the rotating ring and the rotating axis are all required while cooking.
Food and containers should always be placed on the glass plate for cooking.
USE
Connect the power cord to the socket.
Cooking
Turn the function setting knob and select the desired cooking.
Turn the timer knob to select the cooking time.
After selecting the function and cooking time, the oven will begin cooking automatically.
During operation, the internal lamp lights up for all the duration of cooking.
At the end of the set time, the oven automatically stops and a beep sounds.
When the oven is off, check that the timer knob is on 0 position.
17