Specific Safety Rules - Makita 4324 Manual De Instrucciones

ENGLISH
1 Bolt
2 Hex wrench
3 Loosen
4 Blade holder
5 Jig saw blade
6 Roller
7 Hook
8 Dust cover
9 Switch trigger
10 Lock button
SPECIFICATIONS
Model
Length of stroke .................................................................................................................................................... 18 mm
Strokes per minute ....................................................................................................................................... 500 – 3,100
Cutting capacities
Wood ................................................................................................................................................................. 65 mm
Mild steel ............................................................................................................................................................. 6 mm
Overall length ............................................................................ Aluminum base type 214 mm/Steel base type 207 mm
Net weight ........................................................................................Aluminum base type 1.9 kg/Steel base type 1.9 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to jig saw safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body
leaves it unstable and may lead to loss of control.
3. Always use safety glasses or goggles. Ordinary
eye or sun glasses are NOT safety glasses.
4. Avoid cutting nails. Inspect workpiece for any
nails and remove them before operation.
5. Do not cut oversize workpiece.
6. Check for the proper clearance beyond the work-
piece before cutting so that the blade will not
strike the floor, workbench, etc.
7. Hold the tool firmly.
6
Explanation of general view
11 Cutting action changing lever
12 Speed adjusting dial
13 Cutting line
14 Base
15 Bolt
16 Graduations
17 Edge of motor housing
18 Starting hole
19 Hose
20 Rip fence (Guide rule)
8.
9.
10. Do not leave the tool running. Operate the tool
11. Always switch off and wait for the blade to come
12. Do not touch the blade or the workpiece immedi-
13. Do not operate the tool at no-load unnecessarily.
14. Some material contains chemicals which may be
15. Always use the correct dust mask/respirator for
GEB016-1
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
21 Bolt
22 Fence guide
23 Threaded knob
24 Circular guide pin
25 Protrusions
26 Anti-splintering device
27 Alminum base
28 Cover plate
29 Steel base type
30 Aluminum base type
Make sure the blade is not contacting the work-
piece before the switch is turned on.
Keep hands away from moving parts.
only when hand-held.
to a complete stop before removing the blade
from the workpiece.
ately after operation; they may be extremely hot
and could burn your skin.
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
the material and application you are working
with.
4324