Power Cord Connection - Whirlpool WDF518SAHW0 Instrucciones De Instalación

POWER CORD CONNECTION

WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
NOTE: If removing a previous dishwasher with a power cord,
you will need to transfer the power cord to the new dishwasher.
14.
Remove terminal box cover
Remove the screw holding the terminal box cover. Remove the
cover by sliding it up and lifting the hooks out of the slot. Keep
the cover for later use.
15.
Install strain relief
Install a UL Listed/CSA Approved metallic strain relief. Make
sure screw heads are facing up when tightening conduit nut.
Strain relief is provided with the power cord kit. See the "Tools
and Parts" section for part details and ordering information.
12
16.
Select UL Listed/CSA Approved twist-on wire connectors of the
proper size. See the "Tools and Parts" section for part details.
Connect wires, black-to-black and white-to-white, using the
twist-on wire connectors.
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Route cord so that it does not touch dishwasher motor or lower part
of dishwasher tub. Pull cord through strain relief in terminal box.
NOTE: A maximum of two power cord supply conductors
(12 AWG largest size) plus one grounding conductor are
permitted in the terminal box.
Remove the ground connector screw on the raised floor inside
the box and place it through the ring terminal of the green ground
wire of power cord. Reattach and tighten the ground connector
screw to the raised floor of the box. Tighten strain relief screws
Terminal
to secure cord.
box cover
17.
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the floor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the box
and not pinched by the cover.
NOTE: Route power cord out the bottom rear channel provided.
Do not plug cord into an outlet until instructed to do so.
Power cord—route cord into
terminal box
Wiring configuration
Power cord—reinstall terminal box
cover and wires
White
Black
Terminal
box cover