Install Anti-Tip Bracket - Whirlpool WFE775H0HB Instrucciones De Instalación

Install Anti-Tip Bracket

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Remove the anti-tip bracket from where it is taped inside the
storage drawer or warming drawer.
2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor, you can use the wall
mounting method. If you are installing the range in a mobile
home, you must secure the range to the floor.
3. Determine and mark centerline of the cutout space. The
mounting can be installed on either the left side or right side
of the cutout. Position mounting bracket against the wall in
the cutout so that the V-notch of the bracket is 12
(31.9 cm) from centerline as shown.
Centerline
A. 12
9
B. Bracket V-notch
4. Drill two 1/8" (3 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
8
⁄
9
16
B
A
⁄ " (31.9 cm)
16
Floor Mounting
Rear position
Wall Mounting
5. Using the Phillips screwdriver, mount anti-tip bracket to
the wall or floor with the two #12 x 1
provided.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard, or
hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
"
8. Move range forward onto shipping base, cardboard, or
hardboard to continue installing the range using the following
installation instructions.
Diagonal (2 options)
Front position
⁄ " (41 mm) screws
5
8