HQ-Power VDPLC010 Manual Del Usuario página 4

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
• Mechanical wear is not covered by warranty.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.
4. Features
• 5-channel RGB DMX controller
• chase light feature: distribute the effect over (a multiple of) 3 or 4 RGB target devices
• four operation modes: blackout (all off), scene (static on with selectable colour), pattern (chase),
strobe (white 18Hz strobe)
• 9 chase patterns, combinable with 7 colour schemes
• pattern speed setting: manual or sound-controlled
• master output dimming level: 50 - 75 - 100%
• hard (switching) / soft (fading) transition in pattern mode
• handheld-sized road-proof metal case
• mains power adaptor included
• for: VDPLP64B2, VDPLP64B3, VDPLP64C2, VDPLP64C3
5. Overview
Refer to the illustrations on page 2 of this manual.
VDPLC010
1 power switch
2 12VDC/100mA input jack
3 configuration switch
4 DMX output connector
5 DIMMER level (50-75-100%)
6 TRANSITION button (hard – soft)
6. Installation
Refer to the illustrations on page 2 of this manual.
• Install the VDPLC010 in a dry location away from strong magnetic fields.
• Make sure the power switch [1] is off and plug the DC connector of the included mains adaptor into
the 12VDC input jack [2].
• Plug the DC adaptor into a suitable mains outlet.
• Connect an XLR cable to the DMX output connector [4] of the VDPLC010 and the other side to the
male XLR connector of a DMX-controllable light source (not incl.). When light sources with both in-
and output XLR-type connectors are present, multiple light sources can be linked through serial
linking. The linking cable (not incl.) should be a dual core, screened cable.
DMX start address selection
• All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen"
to the DMX controller.
• You can use the same starting address for a whole group of devices or enter an individual one for
every device. When all devices have the same address, all the units will "listen" to the control
signal on one particular channel. In other words: changing the settings of one channel will affect
all devices simultaneously. If you set different addresses, each device will "listen" to a separate
channel number. Changing the settings of one channel will only affect the device in question.
• A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120Ω
22/01/2010
channel 1 red
channel 2 green
channel 3 blue
channel 4 master dimmer (from 0 to 100%)
channel 5 shutter/strobe
0..25
26..229
230..255
VDPLC010
7 PATTERN button (PTN)
8 MODE button (pattern – scene) (MODE)
9 BLACKOUT button (B/O)
10 STROBE button
11 COLOUR button (COL)
12 SPEED button (TAP)
13 microphone
open
slow to fast
open
4
©Velleman nv