Operation; Care And Maintenance - Hilti HDM 330 Manual De Instrucciones

Ocultar thumbs Ver también para HDM 330:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4 Operation

CAUTION
Risk of pinching your fingers! Keep your hands clear
of the cradle area when pivoting the foil pack holder
into position.
WARNING
Observe the information on the safety data sheets, on
the packaging and in the instructions for use before
using the product.
4.1 Selecting and inserting the foil pack
holder 1 2
CAUTION
Check the foil pack holder for damage and/or soiling.
Both pistons in the foil pack holder must move smoothly
and easily in both directions over the full length of their
travel. Damaged and/or badly soiled foil pack holders
must be replaced.
Select the correct foil pack holder according to the color
of the foil pack.
Black foil pack holder: BLACK or WHITE foil pack
Red foil pack holder: RED foil pack
4.2 Inserting the foil pack in the foil pack holder 3
NOTE
Follow the instructions for use of the foil pack.
4.3 Discarding the initial quantity of mortar
dispensed
WARNING
Never point the tool toward yourself or other persons.

5 Care and maintenance

CAUTION
In order to avoid inadvertent ejection of mortar, re-
move the foil pack before beginning to clean the tool.
5.1 Care of the tool
CAUTION
Keep the tool, especially its grip surfaces, clean and
free from oil and grease.
WARNING
The static mixer must always be fitted before dis-
pensing mortar.
1.
Pull the trigger repeatedly towards the grip until
the foil pack opens and mortar is ejected from the
mixing nozzle.
2.
One stroke of the dispenser is achieved by pulling
the trigger all the way to the grip.
3.
Press the release button after the specified number
of strokes.
4.
Discard the initial quantity of mortar dispensed.
5.
The tool is then ready to dispense ready-to-use
mortar.
4.4 Injecting mortar 4
CAUTION
The tool / foil pack must not be under pressure when
the mixing nozzle is changed.
NOTE
Please refer to the instructions for use of the foil pack for
further information about use of the mortar.
1.
Pull the trigger fully toward the grip several times.
2.
Press the release button after finishing dispensing
or if the operation is interrupted.
3.
Pressing the release button prevents further ejection
or leakage of mortar.
4.5 Removing the foil pack 5
4.6 Removing the foil pack holder from the tool 6
Clean the outside of the tool at regular intervals with a
slightly damp cloth.
Lubricate the piston rods with oil when necessary. Mortar
adhering to the tool or the foil pack holder must be
cleaned off with a cloth before it hardens. Hardened
mortar can be removed only by mechanical means. Take
care to ensure that the tool is not damaged by cleaning.
Do not use a spray, steam pressure cleaning equipment
or running water for cleaning. Never dip or soak the tool
or its parts in solvents. Check that the piston moves freely
in the foil pack holder.
en
3

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Hdm 500

Tabla de contenido