Safety Instructions; Work Area Safety; Personal Safety; Personal Protective Equipment - Hilti HDM 330 Manual De Instrucciones

4 Safety instructions

WARNING! Read all instructions! Follow these safety
instructions!

4.1 Work area safety

a) Ensure that the workplace is well ventilated.
b) Ensure that the workplace is well lit.
c) Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
d) Keep children and other persons away from the
area while the tool or appliance is in use. Distrac-
tions can cause you to lose control.

4.2 Personal safety

Stay alert, watch what you are doing and use common
sense when operating the appliance. Do not use the
appliance while tired or under the influence of drugs,
alcohol or medication. A moment of inattention while
operating appliances may result in serious personal injury.
4.3 Power tool use and care
a) Operate the tool only as intended and when it is
in faultless condition.
b) Use only foil pack holders of a type approved for
use with the tool.
c) Do not use damaged foil pack holders or damaged
foil packs.

5 Operation

CAUTION
Risk of pinching your fingers! Keep your hands clear
of the cradle area when pivoting the foil pack holder
into position.
WARNING
Observe the information on the safety data sheets, on
the packaging and in the instructions for use before
using the product.
5.1 Selecting the foil pack holder 2
CAUTION
Check the foil pack holder for damage and/or soiling.
Both pistons in the foil pack holder must move smoothly
and easily in both directions over the full length of their
travel. Damaged and/or badly soiled foil pack holders
must be replaced.
NOTE
Foil pack holders are available as accessories.
Select the correct foil pack holder according to the color
of the foil pack.
Black foil pack holder: BLACK or WHITE foil pack
Red foil pack holder: RED foil pack
d) The tool, the cradle for the foil pack holders,
the piston rods with pressure pieces and the foil
pack holders must be clean and free from foreign
matter.
e) Maintain the tool carefully. Check for misalign-
ment or binding of moving parts, breakage of
parts and any other condition that may affect the
tool's operation.
f) Use the tool and accessories in accordance with
these instructions and in the way specified for this
special type of tool. Take the working conditions
and the work to be performed into account.
g) Do not attempt to open or disassemble the tool.
Repairs may be carried out only by Hilti Service.

4.4 Personal protective equipment

a) Wear personal protective equipment while the
tool is in use: closely fitting protective glasses
or face shield, protective gloves and protective
clothing. Wearing personal protective equipment re-
duces the risk of injury.
b) Persons in the immediate vicinity must also wear
personal protective equipment while the tool is in
use.
5.2 Inserting the foil pack in the foil pack
holder 3 4 5 6 7
NOTE
Follow the instructions for use of the foil pack.
WARNING
Check the foil pack for damage. Never use damaged
foil packs.
1. Press the release button and maintain pressure on
it.
2. Pull the piston rods all the way back.
3. Remove the foil pack holder from the tool by tilting
it slightly and applying light pressure from below.
4. Grip the tool with the foil pack holder from the side
with one hand and push the foil pack into the holder
from the front, as far as it will go.
5. Screw the static mixer all the way onto the foil pack.
en
9