PHARO EL40 Instrucciones De Montaje página 34

Setting/Adjusting
Automatic shower
function switch-off time
15
16
/
17
18
Automatic lighting
switch-off
19
20
/
21
22
Configuration code
23
24
Software code
25
26
Characteristic curve
27
28
/
29
30
34
Press the + (15) button to dis-
play the next program item
P03, the automatic shower func-
tion switch-off time. The value 15
min. is displayed when the
MODE (16) button is pressed.
Use the +/- (17) buttons to ad-
just this value within the range 1
to 50 minutes. Store this setting
with the MODE (18) button.
The display shows P03.
Press the + (19) button to dis-
play the next program item
P04, automatic lighting switch-
off. The value 2 is displayed
when the MODE (20) button is
pressed. Use the +/- (21) but-
tons to adjust this value within
the range 1 to 50 minutes. Store
this setting with the MODE (22)
button. The display shows P04.
Press the + (23) button to dis-
play the next program item
P05, the configuration code. A
three-digit configuration code is
displayed when the MODE
(24) button is pressed.
Press the + (25) button to dis-
play the next program item
P06, the software code. A
three-digit software code is
displayed when the MODE
(26) button is pressed.
Press the + (27) button to dis-
play the next program item
P07, the characteristic curve.
The value 1 is displayed when
the MODE (28) button is
pressed. Use the +/- (29) but-
tons to set the value 0 (No) or 1
(Yes). Store this setting with the
MODE (30) button. The display
shows P07.
The automatic switch-off time of
the shower function determines
the time after which the control
switches back to "Stand by"
operation.
The automatic lighting turn-off
is the time after which the
shower lighting is automatically
turned off.
The configuration code informs
the service technician about the
units connected. It cannot be
changed.
The software code informs the
service technician about the
software used. It cannot be
changed.
This program item serves to
specify whether an automatic
curve correction is desired or
not.