Peg-Perego seat unit Instrucciones De Uso página 7

EN_English
Thank you for choosing a
Peg-Pérego product.
WARNING
• IMPORTANT: READ THESE
INSTRUCTIONS CAREFULLY
AND KEEP THEM FOR FUTURE
REFERENCE. FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD PUT
THE CHILD'S SAFETY AT RISK.
• THIS PRODUCT IS DESIGNED FOR
CHILDREN WHOSE MAXIMUM WEIGHT
IS 45 POUNDS (20 KG) AND WHOSE
MAXIMUM HEIGHT IS 43 INCHES
(110 CM). THIS SHOPPER BASKET IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 11 POUNDS (5 KG). ANY
CUPHOLDER EVENTUALLY PROVIDED
WITH THIS UNIT IS DESIGNED TO
CARRY A MAXIMUM WEIGHT SPECIFIED
ON THE CUPHOLDER ITSELF. ANY
POACH OR POCKET PROVIDED WITH
THIS UNIT IS DESIGNED TO CARRY A
MAXIMUM WEIGHT OF 0.44 POUNDS
(0.2 KG).
• FAILURE TO FOLLOW
MANUFACTURER'S SPECIFICATIONS
OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE UNIT
TO BECOME UNSTABLE.
• AVOID SERIOUS INJURY FROM FALLING
OR SLIDING OUT. ALWAYS USE
COMPLETE 5 POINT SEAT BELT.
• NEVER LEAVE YOUR CHILD
UNATTENDED.
• CHILD MAY SLIP INTO LEG OPENINGS
AND STRANGLE. NEVER USE IN
RECLINED CARRIAGE POSITION UNLESS
FOOTREST ENCLOSURE IS FULLY
INSTALLED/IMPLEMENTED.
• ALWAYS USE ALL THE BRAKES
WHENEVER PARKED.
• TO AVOID SERIOUS INJURY, WHEN
MAKING ADJUSTMENTS ENSURE
THE CHILD'S BODY IS CLEAR OF ALL
MOVING PARTS.
• ALL OPERATING AND ASSEMBLY
PROCEDURES SHOULD BE PERFORMED
BY AN ADULT.
• DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE FRONT
BAR IS NOT DESIGNED TO WITHSTAND
LOADS.
• ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED IN
POSITION OF USE.
• CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
• DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE MUST
BE TAKEN IF UNIT IS USED ON STAIRS
OR ESCALATORS.
• DO NOT USE THE PRODUCT IF IT HAS
BROKEN OR MISSING PARTS.
• DO NOT USE NEAR FIRE OR EXPOSED
FLAME.
• NOTICE: THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
instructions for use
CARRIER SEAT
• PrimoGiro Seat Unit: the carrier seat for the
PrimoNido bassinet unit. This seat comes with a
cover only, since the hood from the PrimoNido
bassinet unit can be used with the seat once
the baby no longer uses the bassinet unit. The
hood can also be ordered separately.
• Duette and Triplette Seat Unit: the carrier
seat for the Duette and Triplette twin carriages.
This seat comes with a cover and a hood with a
zipper that can also be used as a canopy.
SEAT FITTING
1• Fold back the footrest and raise the backrest to
the desired position by pulling the handle on
the rear of the backrest, as shown in the figure.
2• To fit the front bar, remove the plugs onto the
armrests pushing from underneath and detach
the squared bushes from the armrests.
3• Insert the front bar into the armrests and
complete the fitting by replacing the plugs into
the armrests.
TO FIT AND REMOVE THE SEAT
Before fitting and removing the seats, always
apply the brake.
4• To fit the seat to the frame, place it as shown
in the figure and press down with both hands
till it clicks. The seat can be mounted facing the