Troubleshooting Table - babymoov A014407 Instrucciones De Uso

- Temperature alarm: ON
- Select alarm time repitition (5 s, 10 s, 30 s, 1 min)
H34 & H35. Volume
- Volume from 1
Problem
• No audio or video signal is transmitted.
• Permanent transmission.
• Alarm out of range permanently activated.
• The image on the screen is not homogeneous or
is fixed or appears in black and white.
• Lots of static noise and interference.
• Range of action too small.
16
/ OFF .
ON OFF
to 6 .
1 6
TROUBLE SHOOTING TABLE
Possible Causes
• The microphone's sensitivity is too low.
• The mains adapter is not connected correctly to
the transmitter.
• The microphone's sensitivity is too high.
• The distance between the transmitter and the
receiver exceeds the range of action.
• The limits of the range of action have been reached.
• The light intensity is too weak in the baby's room;
the unit functions in night vision mode and so uses
the infrared LEDs as lighting source.
• The transmitter is placed beside other
electric appliances.
• There must be a lot of partitions between the
receiver and the transmitter.
BABY MONITOR TOUCH SCREEN • Instructions for use
.
BB - BB
• Increase the microphone's sensitivity by means of
the adjustment system.
• Verify the connection.
• Diminish the microphone's sensitivity by means of
the adjustment system so that the transmitter is
activated by the voice.
• Bring the receiver and the transmitter closer together.
• Move the receiver closer to the camera.
• Increase the light in the baby's room.
• Remove the electric appliances or the transmitter
to remove the source of interference.
• Move the transmitter and the receiver.
Solutions