Troubleshooting Guide - babymoov Premium Care Instrucciones De Uso

Problem
No sound on the receiver
Transmission always on
Audible alarm
permanently activated
Always showing low battery alert
Battery life is short
Communication frequently
Interrupted
Too short communication range
10
TROUBLE SHOOTING GUIDE
Possible cause
• The microphone's sensitivity is too low.
• The power adapter is not properly connected.
• VOX mode active.
• Battery empty.
• The VOX mode sensitivity is too high.
• Transmitter battery is run down.
• Distance between baby and parent unit exceeds
the operating range.
• Battery has run down.
• Battery pack is damaged.
• Night light is permanently switched on.
• Vibration alert is switched on.
• Baby unit is located near other electrical
appliances.
• Using the babyphone on a power strip.
• Many steel structures between baby & parent unit.
• Baby unit battery has run down.
BABY MONITOR PREMIUM CARE • Instruction manual
Solution
• Increase the receiver volume.
• Check the connection.
• Press a button to activate the screen.
• Charge your receiver.
• Reduce the sensitivity of the VOX mode (19).
• Recharge battery using AC adapter.
• Move the baby & parent unit closer together.
• Recharge battery using AC adapter
(parent unit).
• Replace with new battery or use AC adapter
(baby unit).
• Replace with new battery pack.
• Switch off night light or set to VOX operate.
• Switch off vibration alert.
• Remove the electrical appliances or re-locate
the baby unit far away from source of
interference or perform pairing again.
• Do not connect your baby monitors to power
strips.
• Re-locate baby or parent unit.
• Replace with new battery or use AC adapter.