Prepare The Grill For Lighting - KitchenAid 720-0709C Instrucciones De Instalación Y Manual De Uso Y Cuidado

Asador autónomo para exteriores
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Prepare the Grill for Lighting

1. Open the hood completely. Do not light burners with the hood
closed.
2. Make sure control knobs are turned to OFF. The grease cup
must be in place.
Turn the Gas Supply On
1. For using a 20 lb LP gas fuel tank: Slowly open the tank valve.
1 For using a 20 lb LP gas fuel tank: Slowly open the tank valve
NOTE: If flow limiting device activates, your grill may not light. If
your grill does light, the flames will be low and will not heat
properly. Turn tank valve and all control knobs off and wait 30
seconds. After shutting off the tank, very slowly open tank valve
and wait 5 seconds before lighting.
2. For outdoor grills using gas supply source other than a 20 lb
LP gas fuel tank:
Open the manual shutoff valve in the gas supply line. The valve
is open when the handle is parallel to the gas pipe.
i
h
h h
dl i
Lighting the Grill
1. Open the hood completely. Do not light burners with the hood
closed.
2. Do not lean over the grill.
3. Select the burner you want to light.
Push in and turn the grill burner control knob to IGNITE/HIGH
or IGNITE/ON, while continuing to hold it in.
22
( )
(D) Grease Cup
ll l
h
i
4. You will hear the "snapping" sound of the spark. When burner
is lit, release the knob. Turn knob to desired setting.
5. Repeat for each of the other burners as needed.
IMPORTANT: If burner does not light immediately, turn the burner
knob to OFF and wait 5 minutes before relighting.
Manually Lighting the Grill
1. Open the hood completely. Do not light burners with hood
closed.
2. Do not lean over the grill.
3. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
p
4 Strike the match to light it
4. Strike the match to light it.
5. Guide the lit match between the grill grate.
6. Push in and turn the burner knob to IGNITE/HIGH or
IGNITE/ON for the burner closest to the lit match. The burner will
light immediately. When burner is lit, turn knob to desired setting.
7. Repeat steps 2 trough 6 for each main burner.
8. Remove match and replace manual lighting extension inside
the cabinet door.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
If burner does not light immediately turn the burner knob to OFF
and wait 5 minutes before relighting. If any burners do not light
after attempting to light them manually, contact the Customer
Service Center. See the " Assistance or Service" section.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

730-0709c

Tabla de contenido