Auxiliary Handle - Bosch GSB18V-755C Instrucciones De Funcionamiento

2610045251.qxp_GSB18V-755C GSR18V-755C 6/25/18 11:01 AM Page 10

AUXILIARY HANDLE

The tool must be supported with the auxiliary
handle during operation.
To mount the auxiliary handle on the tool loosen
the hand grip (A). Pull on the sleeve (B) and
slide the collar on to the tool as shown (C).
Swivel the handle to desired position (D).
Secure the handle in place by tightening the
hand grip (E). See Fig. 5.
To remove the handle for transportation or
storage reverse the steps above.
GCY30-4 CONNECTIVITY MODULE
INSTALLATION
To reduce the risk of injury
read
instructions included with Bosch GCY30-4
connectivity module. Operating instructions for
GCY30-4 connectivity module include important
information not covered in this manual.
Only use Button/coin cell 3V
lithium CR2032 battery. Do
not use any other button/coin cells or other forms
of electrical power supply.
replacement is carried out
properly. There is a risk of explosion.
Keep batteries away from
children. This product contains a lithium
button/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or enters the
body, it can cause severe internal burns and can
lead to death in as little as 2 hours. If you think a
battery might have been swallowed or placed
inside any part of the body, seek immediate
medical attention.
Always completely secure
the connectivity module
compartment. If the connectivity module
compartment does not close securely, stop using
the product, remove the battery, and keep it away
from children.
When discarding batteries,
insulate the '+' and '–'
terminals with insulating tape. When disposed
of improperly, lithium batteries may short, causing
them to become hot, burst or ignite.
batteries in a fire or expose
to high heat. The batteries may explode.
10
the operating
Ensure that battery
Chemical Burn Hazard.
Never dispose of
SAVE THESE INSTRUCTIONS
A
B
HAND GRIP
If GCY30-4 connectivity module is not purchased
with the tool, or if the replacement of the module
or the battery becomes necessary, please follow
this procedure (see Fig. 6):
- Using a flat screwdriver or a coin, remove the
cover 1 from the side of the handle, by turning
it 1/4 turn counter-clockwise.
- If the tool is already equipped with the
connectivity module, remove the battery 2, but
do not remove the connectivity module 3.
- If the connectivity module is installed for the
first time, remove the plastic placeholder 4
from the connectivity module compartment,
and place the connectivity module 3 in the
compartment observing correct orientation.
Note: Store the placeholder 4 in a safe place.
Reinsert the placeholder again if the
communications module is removed.
- Next place new battery 2 on the top of the
connectivity module with the "+" polarity facing
up.
the
- Place the cover 1 over the battery and turn it
¼-turn clockwise to lock using a flat
screwdriver or a coin.
E
SLEEVE
D
C
COLLAR
FIG. 6
1
2
3
4
FIG. 5