Power Amp (Sold Separately) - Pioneer MVH-X300BT Manual De Instrucciones

C:\Program Files (x86)\Adobe\AdobeFrameMaker12\Structure\xml\Pioneer\1.0\020Chapter.fm
PioneerTest.book Page 24 Friday, March 16, 2018 4:39 PM
Perform these connections when
using a subwoofer without the
optional amplifier.
Important
In the case of above, two 4 Ω
subwoofers wired in parallel will
represent a 2 Ω load.
To power cord input
Left
Right
24
En
Front speaker
NOTE
Rear speaker
Change the initial menu of this unit.
White
Refer to [SP-P/O MODE] (page 7). The
White/black
subwoofer output of this unit is
Gray
monaural.
Gray/black
Green

Power amp (sold separately)

Green/black
Perform these connections when
Violet
using the optional amplifier.
Violet/black
MVH-X300BT
Black (chassis ground)
Connect to a clean, paint-free
metal location.
Yellow
Connect to the constant 12 V
supply terminal.
Red
Connect to terminal controlled by
the ignition switch (12 V DC).
Blue/white
Connect to the system control
MVH-S315BT
terminal of the power amp or auto-
antenna relay control terminal
(max. 300 mA 12 V DC).
Subwoofer (4 Ω)
When using a subwoofer of 2 Ω, be
sure to connect the subwoofer to
the violet and violet/black leads of
this unit. Do not connect anything
to the green and green/black leads.
Not used.
Subwoofer (4 Ω) × 2
Orange/white (Only for MVH-
X300BT/X700BT)
Connect to a car's illumination
signal.
Installation
• Check all connections and systems
• Do not use unauthorized parts as
• Consult your dealer if installation
• Do not install this unit where:
• Install this unit away from hot places
• Optimum
• When installing, to ensure proper
System remote control
Connect to blue/white cable.
Power amp (sold separately)
Connect with RCA cables (sold
separately)
To front output
Front speaker
To rear output or subwoofer output
Rear speaker or subwoofer
MVH-X300BT/MVH-X700BT/MVH-S315BT
19_812_813ME_QRI3105(B6_Horizon)
Important
before final installation.
this may cause malfunctions.
requires drilling of holes or other
modifications to the vehicle.
– it may interfere with operation of
the vehicle.
– it may cause injury to a passenger
as a result of a sudden stop.
such as near the heater outlet.
performance is
obtained when the
unit is installed at an
angle of less than 60°.
heat dispersal when using this unit,
make sure you leave ample space
behind the rear panel and wrap any
loose cables so they are not blocking
the vents.
Leave ample
5 cm
space
5 cm