Connecting To Separately Sold Power Amp - Pioneer ANH-P9R-BK Manual De Instalación

Connecting the Units

Connecting to separately sold power amp

Note:
When a subwoofer is
connected to this unit
instead of a rear speaker,
change the rear output
setting in the Initial Setting.
(Refer to the Operation
Manual.)
The subwoofer output of this
unit is monaural.
Rear output or
subwoofer output (R)
GPS aerial jack
Refer to Power cable
connection on page 8.
The pin position of the ISO connector will differ depending
on the type of vehicle. Connect 6* and 7* when Pin 5 is an
antenna control type. In another type of vehicle, never
connect 6* and 7*.
• In the case an auto antenna is installed, either turn off
the ignition switch or detach the front panel to put
away the antenna.
10 En
All manuals and user guides at all-guides.com
IP-BUS input (Blue)
Refer to System
connection on page 12.
Blue/white (6*)
Front output (F)
This Product
Antenna jack
Refer to Power cable
connection on page 8.
System remote control
Blue/white (7*)
To Auto-antenna relay control terminal
(max. 300 mA 12 V DC).