Main Working Elements Of The Machine - Corghi MONSTER AGTT Manual De Uso

Fig�10 shows the safety distances and the positions used by the operator during the
various work phases:
A Positioning the wheel on the turntable
B REAR bead breaking
C FRONT bead breaking, demounting and mounting�
MAIN WORKING ELEMENTS
WARNING
Get to know your machine: your familiarity with its exact operation is the best guar-
antee of safety and performance.
Learn the function and location of all commands.
Carefully check that all controls on the machine are working properly.
The machine must be installed properly, operated correctly and serviced regularly in
order to prevent accidents and injuries.
A Main switch
B Control lever
C Pressure gauge
D Lifting point
E Electrohydraulic power unit
F Turntable
G Bead breaker disc
H Tool
I Tool arm
L Display
M Side To Side
N Potentiometer
Start the machine with the main switch (A, Fig� 11) and make sure that the hydraulic
power unit motor is rotating in the direction indicated by the arrow (A, Fig� 12) which can
be seen on the motor cap�
Otherwise, the rotation direction must be corrected immediately in order not to damage
the pump unit�
All machine parts are powered by low voltage (24V), with the exception of the hydraulic
power unit and the turntable rotation motor, which are powered with mains voltage�
WARNING
Make sure that all parts of the hydraulic circuit are tightened correctly. If pressurised
oil escapes, it can cause serious injury.
WARNING
The machine is equipped with devices that guarantee the operator's safety:
Operator's manual MONSTER AGTT
OF THE MACHINE
UK
47