Before fitting or removing the tyre, lubricate the beads carefully to protect them
against possible damage and to facilitate fitting and removal operations�
For the areas to lubricate, refer to figures 38 (mounting tubeless tyres), 39 (demounting
tubeless tyres) and 38a (mounting tyres with an inner tube and protector)�
WARNING
It is prohibited to use hydrocarbon based lubricants (oil, petroleum, etc.) or other
substances that maintain the lubricating effect over time.
WARNING
This tyre changer for heavy vehicles makes it possible to work safely always close to
the ground!
Lift the heavy tyres as little as possible up off the ground before performing the
demounting/mounting operations
Lock the wheel on the turntable� Lift it off the ground as little as possible�
Using the + / - buttons and the display, set the rim diameter (command 12 fig� 13)� With
this operation the rim will be positioned perfectly tangent to the bead breaker disc�
If the dimension is already entered, simply press the "disc tangency" button to position
the wheel to the bead breaker disc�(fig� 23)�
If necessary, the wheel can be moved manually towards/away from the bead breaker
disc�
DEMOUNTING AGRICULTURE WHEELS
BEAD BREAKING
When the tyre is deflated, turn the turntable in continuation, moving it a little at a time
using the specific control�
To make the bead breaking operation quicker, operate the control that adjusts the
rotational speed�
N�B� In the case of radial tyres with a delicate side or rims with a very high edge,
move the bead breaker to a depth between the rim edge and the bead, as far as the
base of the shoulder of the rim�
When the bead breaking is complete, lubricate the bead and the shoulder of the rim
using the specific grease or a soapy solution, keeping the wheel in movement�
Use the S�T�S� + function to move the tool unit from the other side of the wheel, turned
(fig� 24)�
N�B� If the wheel is very heavy, the tool unit should be moved manually from the other
side, not using the second speed for safety reasons�
Repeat the same operations for rear bead breaking�
Return the tool holder arm to the front part using the S�T�S� command�
Operator's manual MONSTER AGTT
LUBRICATING TYRES
WHEEL LOCKING
UK
55