Lubrification; Topping Up Coolant - Benelli BN302 Manual Usuario

EN

Lubrification

The chain must only be lubricated at an
Authorised Benelli Workshop, at the
time intervals speciied in the Scheduled
Maintenance Table in this manual.
This operation must also be carried out
every time you ride the bike in rain and
after each wash.
Using the motorcycle with the chain in
bad condition and not lubricated may
cause accidents.
The chain must be correctly lubricated
to guarantee maximum eficiency. Use
Petronas 6 in 1.

TOPPING UP COOLANT

The cooling system serves to cool the
recirculating water and allow the engine
to operate in optimum conditions.
Make sure the coolant is at the correct
level in the tank as described in the
dedicated section.
If the coolant level is below the minimum
(MIN), top up as described:
• Place the vehicle on a lat surface
and keep it upright.
• Remove the cap "A" from the coolant
tank and add more coolant as far as
the (MAX) level, making sure not to
exceed this.
https://www.motorcycle-manual.com/
The cooling luid must only be topped up
when the engine is cool.
Never try to remove the cooling fluid
tank cap while the engine is hot. Risk of
burns. The circuit is pressurized!
In certain conditions, the ethylene glycol
in the cooling luid may become
MAX
flammable and its lame is invisible.
MIN
Do not allow cooling luid to come into
contact with hot parts, as the combustion
of ethylene glycol may expose you to the
risk of burns.
Engine cooling luid is harmful if
swallowed, or if it comes into contact
with eyes or skin.
Keep the engine cooling luid out of
reach of children and pets.
In the event of swallowing cooling luid,
seek medical aid immediately; do not
provoke vomiting to avoid breathing the
product into the lungs.
In case of cooling luid in contact with
A
eyes or skin rinse immediately with
plenty of water.
100
IMPORTANT NOTICE