it is hot.
5.6 Turning off the machine
1) Turn the main switch (Fig. 01; pos. 1) to position
"0" and check that the green light has turned
off. (Fig. 01; pos. 11)
2) Turn off the intercepting water tap (R version).
6 - MAINTENANCE
To allow the machine to work correctly, follow the
maintenance instructions provided below.
6.1 Safety rules
Do not subject the machine to water jets. Dis-
connect the machine from the electrical power
by turning the electrical power network omnip-
olar knife-switch lever to the resting position 0.
Remove the plug and close the water intercep-
tion tap before carrying out maintenance and/
or cleaning work. If the machine is malfunction-
ing, do not attempt to repair it alone and call
the technical assistance service immediately. If
the electrical power cable has been damaged,
turn off the machine immediately, turn off the
water and call the technical assistance service.
Do not replace it alone. Carry out cleaning/
maintenance when the machine is cold, prefer-
ably wearing protective gloves.
6.2 Cleaning the machine
These recommendations are indicative.
Maintenance and cleaning frequency depends on
machine use.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and filters
Daily
1) Clean the cup holder grill and drain tank
2) Clean the machine body
Weekly
1) Clean the unit seal with the brush provided (Fig.
07).
2) Clean the water tank.
Monthly
1) Submerge the filter holders and filters in boil-
ing water for a few minutes to dissolve coffee
grease, use a cloth or sponge to remove resi-
due.
Do not use solvents, detergents or abra-
sive sponges for washing and cleaning.
Clean the machine body with a cloth
dampened in water and/or neutral de-
tergents, carefully drying surfaces before recon-
necting the machine to the power supply. Use water
to clean the cup holder grill and drain tank. Use
water and neutral detergents to clean the tank after
removing it. When finished rinse thoroughly.
6.3 Safety thermostat - Manual re-
arming
Warning!
scribed below is only relevant to
an installing technician who is
authorised by the manufacturer.
While the machine is working, the boiler resistance
may overheat and, cutting off power, sets off the
safety thermostat that prevents any further damage
to the boiler. To restore normal operations, resolve
the malfunction that triggered the safety thermostat
and restore normal conditions by pressing the red
button (RESET) (Fig. 08).
6.4 Correct product disposal
(electrical and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection sys-
tems).
The sign carried on the product or on its
documentation indicates that the prod-
uct must not be disposed of with other
domestic waste at the end of its life cy-
cle. To avoid any damage to the environment or to
health, caused by unsuitable waste disposal, the
user is asked to separate this product from other
types of waste and to recycle it responsibly to help
the sustainable recycling of material resources.
Domestic users are invited to contact the dealer
where the product was purchased or the local of-
fice in charge of this matter for all the information
relating to separate waste collection and recycling
for this type of product.
Company users are invited to contact their own
supplier to check the terms and conditions of the
purchase contract.
This product must not be disposed of together with
other commercial waste.
29
BEZZERA STREGA
MOD.
The
operation
de-