Storage; Troubleshooting; Specifications; Motor - Toro 51450 Manual Del Usuario

2. Keep the air vents free of obstructions.
3. Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by
certain household cleaners that contain aromatic
oils such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a
shock hazard. Wipe off any moisture with a soft
cloth.

Troubleshooting

Problem
Motor Will Not Start
Cutting Head Will Not Turn When
Trigger Is Squeezed
Cutting Head Will Not Advance Line Cutting head out of line
If further assistance is required, contact your local authorized Toro service dealer.

Specifications

Motor

Motor Type
Operating RPM
Ignition Switch
Amperage
EN–9
Cause
Motor stops/will not start
Cutting head bound with grass or
debris
Inner reel bound up
Cutting head dirty
Indexing teeth worn or burred
Line welded
Line twisted when refilled
Not enough line is exposed
Electric 110/120 VAC
7000-7800 rpm
Trigger
4.7 amps

Storage

Clean the unit thoroughly before storing it. Hang the
unit by the handle loop. Store the unit in a dry,
well–ventilated area.
Check cord to see if it is plugged
into an electrical outlet
Stop motor and clean cutting head
Refill with new cutting line
Replace inner reel
Clean reel and spool
Replace reel and spool
Disassemble, remove the welded
section and rewind the line
Disassemble and rewind reel
Push the Bump Knob and pull out
4 in (102 mm) of line until the line is
outside of the cutting head
Drive Shaft & Cutting Head
Drive Shaft
Drive Shaft Housing
Line Spool
Line Spool Diameter
Trimming Line
Diameter
Cutting Path Diameter
Action
1/4 in (6.5 mm)
Aluminum Tube
Bump Line Releaser
3 in (76.2 mm)
0.060 in (1.52 mm)
15 in (381 mm)