JVC LT-24HD7WU Instrucciones De Funcionamiento página 31

DVD OPERATION
Note: This function is available only when the disc have rating encoded on.it wil ask a password
when you select a level except for Adult.The factory setting of the password is 6666.
Press Down button to the OK after finishing input of the password,then press OK button to
confirm and go back to the previous menu.
Password:Reset the password.The password should be 4-digit,and the initial password is 6666.
Note:Press Down button to the OK after finishing input of the password, then press OK button
to confirm and go back to the previous menu.
If you forget the old password, you can always use the factory setting password 6666.
Default: Default the factory' settings EXCEPT the password.
If you have any questions, please consult the troubleshooting guide below:
NO PICTURE OR SOUND
Ensure the TV is switched on (ie. not in
Stand-by mode).
Ensure the power outlet is operational.
Ensure the power cord is not damaged.
Ensure the power plug is connected
firmly to the mains outlet.
PICTURE BUT NO SOUND
Ensure the audio is not set to mute.
Ensure you have set the player s AUDIO
settings correctly.
POOR PICTURE OR SOUND
Ensure you have set the player's AUDIO
and PICTURE settings correctly
Ensure the disc is not scratched or
stained.
"BAD DISC"DISPLAYED
Ensure the disc is not warped,
damaged or deformed.
Ensure the disc is not badly stained or
damaged.
Ensure the disc format is compatible
with the player.
Please check whether you have tried to
play a software CD. If so, please restart
the player using a music CD or DVD.
Make sure that the disc is not upside
down (the label side should be facing
you when viewed from the front of the
TV).
REMOTE NOT WORKING
Make sure the Main unit s POWER button is on
Ensure the remote batteries are working.
Point the remote control directly at the player's
IR sensor.
Remove any obstacles between the remote
and the IR sensor.
UNIT NOT WORKING
Turn off the power, and then turn it on
,
again.
"NO DISC"DISPLAYED
Ensure you have put the disc in the slot.
Ensure the disc is not distorted, stained or
scratched.
EN
31