Milwaukee 5455 Manual Del Operador página 6

Wool/Polyester Bonnets
1. To install wool/polyester bonnets, unplug the tool
and place it on a tool rest with the spindle upright.
2. Make sure the washer flange and spindle washer
are installed on spindle. Then, slide the rubber
backing pad onto the spindle.
3. Push in the spindle lock button and screw the disc
nut onto the spindle clockwise. Securely hand-
tighten the disc nut.
4. Cover the rubber backing pad with the bonnet.
Securely tie bonnet strings and tuck the strings into
the bonnet so they do not interfere with polishing.
5. To remove, untie and remove the bonnet. Push in
the spindle lock button and turn the disc nut and
rubber backing pad counterclockwise.
Wool/polyester
bonnet
Bonnet strings
Disc nut
Rubber
backing pad
Spindle washer
Washer flange
Spindle
Tool rest
Hook and Loop Pads
Hook & loop pads are available in both wool/polyester
and foam. Foam pads should be used on slower/low
speed dial settings when using polisher Cat. Nos.
5540 and 5460. Foam pads are not recommended
for the inexperienced operator.
Foam pad Cat. No. 49-36-1550 is ideal for use
with clearcoat finishes and micro-fine rubbing
compounds. It will remove light surface scratches,
environmental pollutants, wet-sanding scratches
and hazy paint.
Foam pad Cat. No. 49-36-0650 is ideal for glazing
and finishing on clearcoat finishes. It will remove buff-
ing swirls, hard water spots, carwash brush swirls and
mild hazing. A centering tool, Cat. No. 49-67-0130,
is supplied with hook and loop backing pads, Cat.
No. 49-36-2150, to properly align the backing pad
with the polishing pad, providing the proper balance
for your polisher.
1. To install hook and loop pads, unplug the tool and
place it on tool rest with spindle upright.
2. Make sure washer flange and spindle washer are
installed on spindle. Then slide hook and loop
backing pad onto spindle.
3. Push in the spindle lock button and spin the
backing pad clockwise until it is securely hand-
tightened.
4. Insert the centering tool (supplied with the back-
ing pad) into the center hole in the hook and loop
backing pad. Push desired hook and loop polishing
pad over the centering tool so that the polishing
pad fastens to the hook and loop backing pad.
Remove centering tool.
5. To remove, "peel" off the polishing pad. Push in
the spindle lock button and rotate backing pad
counterclockwise to remove.
NOTE: Use side handles for better control and safety.
6
Foam pad with
hook and loop
Centering tool
(remove before
using tool)
Backing pad with
hook and loop
Spindle washer
Washer flange
Spindle
Tool rest