Remote Control Input (Rs-232C) Connector Setting; Trigger Signal Output Setting; Restoring Factory Settings; F/W - Esoteric Grandioso C1X Manual Del Usuario

MENU 3 (continued)
Remote control input (RS-232C) connector
setting
RS232C>***
Set this to ON only when using the remote control input (RS-232C)
connector.
o By default, the setting is OFF.
OFF
The remote control input (RS-232C) connector cannot be used.
ON
The remote control input (RS-232C) connector can be used.

Trigger signal output setting

TRIG_O>***
o By default, the setting is OFF.
OFF
Do not output trigger signals.
ON
Output trigger signals.

Restoring factory settings

SETUP>***
Use to restore the factory default settings, erasing all changes in
memory.
Follow the procedures below to initialize the settings.
1) Use the INPUT (l/;) buttons to show "CLR".
2) While "CLR" is shown, press and hold the SETUP button.
24

F/W **.**

This shows the firmware version.
"**.**" is the version.