JB Systems Light ILEAD CONTROLLER Manual De Instrucciones página 8

ENGLISH
CREATE A CHASE
1. Enter Program mode.
2. Create a scene.
3. Press SAVE button. Select a position ( 1 ~ 24 ) where you want to store the
scene.
4. Repeat steps 2 & 3 as many times as you want until the controller's memory is
full. The SAVE LED will blink when the memory is full.
5. A chase (The controller ) can store up to 485 scenes.
RUNNING SCENES
1. Enter Program mode.
2. Press MEMORY button.
3. Press a button 1~12 or press PAGE select button 13~24 for manually running a
scene.
4. Press the same button again. The second scene will be run after the first
scene.
Note:
The SAVE button is used to store the current status into memory.
The PAGE button is used to select the position of memory. The controller has 24 position in which you
can save chases ( shows ) into them. When the upper LED is on, then button 1 = memory 1, button 2 =
memory 2... etc, when the lower LED is on then button 1 = memory 13, button 2 = memory 14... etc.
The MEMORY button is used to read exiting scenes. The LEDs will light up if there is memory saved
into the buttons.
INSERT A SCENE
1. Enter Program mode.
2. Press the MEMORY button, choose the desired position (1 ~ 24) in which you
want to insert a scene.
3. Select the scene where you want to insert a scene. Press the same button (
e.g. 6 ) repeatedly, you can view the scene one by one.
4. Create a new scene.
5. Press SAVE.
6. Press the desired position ( 1~24 ) you selected again to insert the new
scene.
OVERWRITE A SCENE
1. Enter Program mode.
2. Press the MEMORY button.
JB SYSTEMS 11/71
®
OPERATION MANUAL
iLEAD Controller
ENGLISH
3. Press the button ( 1 ~ 24 ) where the memory ( chase ) is saved and select
the scene that you wish to overwrite.
4. Press the same button ( e.g. 6 ) repeatedly, you can view the scene one by
one.
5. Create a desired scene.
6. Hold down the SAVE button and then press former selected button ( 1 ~ 24 )
to overwrite a scene.
DELETE A SCENE
1. Enter Program mode.
2. Press the MEMORY button, choose the desired position (1~24) in which you
want to delete a scene.
3. Select the scene that you want to delete.
4. Hold down CANCEL and then press the former selected button to delete a
scene.
COPY A CHASE
1. Enter Program mode.
2. Press the MEMORY button.
3. Select an existed chase which you want to copy.
4. Hold down PAGE and then press a button ( 1 ~ 24 ) where you want to copy
the chase into it.
DELETE A CHASE
1. Enter Program mode.
2. Press MEMORY button.
3. Hold down MEMORY button and then press a 1~12 button or press PAGE to
select a 13-24 button to delete a chase.
JB SYSTEMS 12/71
®
OPERATION MANUAL
iLEAD Controller