Twin-Star International 35HF500GRA-ESP Manual De Instrucciones página 4

TOOL REQUIRED
Magnetic Phillips Screw Driver
Rotary Hammer / Electric Drill
Unpacking the Electric Fireplace
WARNING! Do NOT use this Electric Fireplace if any part has been
under water. Immediately call a qualified service technician to inspect
and to replace any part of the electrical system if necessary. Keep plastic
wrapping away from children.
Open the packaging carefully and remove the foam.

Remove and discard the plastic bag.

Be responsible when handling the packing materials.

Keep the original packaging for future transport and/or storage.

Check all accessories are got before you keep the packing.

LOCATING YOUR ELECTRIC FIREPLACE
Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location ensure that the
general instructions are followed. For best results, install out of direct sunlight. Power supply service must be either completed or
placed within the electric fireplace prior to finishing to avoid reconstruction.
CAUTION: Set the cable always as below picture.
HEAT OUTLET
WARNING ! Keep drapery and other furnishings at least 3ft /0.9m from the front and sides of the electric fireplace.
Clearance to Combustibles
Sides ......................................... 2 in. ( 50 mm )
Floor ... ................................. 11 3/4 in. ( 300 mm )
Top ........................................... 0 in. (
Back ...... .....................................0 in. (
INSTALL YOUR FIREPLACE ( Fig. 2) :
Open the box and take out the wall mounting bracket.

Choose a solid and plain wall and then put the bracket on the position where you want to install the fireplace. Mark the 4

holes by a pen from the holes on the bracket. (Fig. 3)
INSTALATION INSTRUCTION
CABLE
0 mm )
0 mm )
Fig. 2
CABLE
HEAT OUTLET
E-3
Fig. 3