Twin-Star International 35HF500GRA-ESP Manual De Instrucciones página 7

OPERATING INSTRUCTIONS-CONTROL FUNCTIONS
This appliance can be operated by both remote control and manual button. Once the unit has been properly
connected to an earthed electrical outlet, turn on the main power switch located on the left hand side of the appliance.
A beep should be heard when the power is first applied.
CAUTION ! The unit's power cord must be connected to a properly grounded and protected 120V outlet.
Always use ground fault protection where required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged,
NOTE ! To use both remote and manual function. As the main power switch must be in " ON" position.
Operating by Manual Button
NOTE! The manual button on the fireplace unit is not provide you with all function control, and its propose is
to control some basic function when you lose the remote handset. Please use the remote handset to carry out all functions.
TO ACCESS CONTROL PANEL
Control panel can be accessed at upper-right side of the fireplace. (Fig. 10 )
Main Power Switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the "ON" position
for any of the functions including the remote to work.
Flame Button
By pressing the FLAME button the unit will cycle through eight flame and backlight effect. If you need more flame.
and backlight effects, please use the remote handset.
Heater Button
Press once HEATER button left hand heater on. (Pilot lights illuminated ●○).
Press again turns left hand heater off and right hand heater on. (Pilot lights illuminated ○●).
Press third time turns left and right hand heater on at the same time. ( Pilot lights illuminated ●●)
Press fourth time turns left and right hand heater off. ( Pilot lights illuminated ○○).
There are 4 levels you can cycle through including the OFF setting.
please call a qualified service technician to inspect and to replace any part of the electrical system
if necessary
Fig. 10
.
E-6
Fig. 11
Main Power
Switch