Powis Parker FASTBACK 15xs Manual Del Usuario página 14

S P E C I A L F E A T U R E S
13
a. To change the bind mode to HALFBACK™, enter the Special
Functions Menu, and cycle through the menu until you see "HALFBACK."
Press BIND to select it.
b. Using the OPEN or EDIT button, cycle through the two choices:
HALFBACK ON and HALFBACK OFF. Press BIND to select the
appropriate mode.
If you change the bind mode, the binder flashes "MODE SAVED" to confirm
your change.
You can always tell what mode you're in just by looking at the display.
NOTE:
If there's no book in the binder, and you're in HALFBACK OFF mode, the
display screen reads, "READY TO BIND." For Halfback™ mode, the screen
says, "HALFBACK READY." When you are in Halfback™ bind mode and you
have a document clamped, the display will tell you the document's width,
prefaced by "HALFBACK." (If you're in HALFBACK OFF mode, the display
shows only the document's width.)
3. Setting the Bind Time
This feature allows you to increase or decrease the total bind time. You
can add up to 15 extra seconds for hard-to-bind paper. You can also
decrease the default bind time by 5 seconds when required.
a. After selecting the BIND TIME menu feature, the default message is:
b. You can now adjust the bind-time in five-second increments.
Add time by pressing the EDIT button. Decrease bind time by pressing the
OPEN button.
c. When you have finished modifying the time, press BIND.
d. Insert the correct width strip, and the Fastback® will bind your
document in the amount of time that has been selected. During binding,
the screen briefly displays the changed bind-time.
Unless a certain weight or type of paper is found to be more difficult to
NOTE:
bind, it is not recommended to add or subtract seconds to the bind time.
F A S T B A C K ® M O D E L 1 5 x s U S E R ' S M A N U A L , R E V . C — 7 / 1 9 / 0 2
+ 00 SE CO ND S
13