Powis Parker FASTBACK 15xs Manual Del Usuario página 34

P R O B L E M S O L V I N G
DIAGRAMA/SCHÉMA/FIGURE 21
DIAGRAMA/SCHÉMA/FIGURE 22
DIAGRAMA/SCHÉMA/FIGURE 23
W A R N I N G :
platen may be extremely
hot! Use the heat
!
protective glove and
tweezers when working
with the platen.
33
B. Opening the Fastback® Cover
If you ever need to work or clean inside the Fastback® binder, you
must open the cover.
1. Switch the power off.
2. Reach under the cover, and pull the release catch forward (figure 21),
until the top cover pops up slightly. Gently push the cover backward
until it stops in the upright position.
C. Removing Jammed Superstrips™
Sometimes Superstrips™ can get stuck inside the binder. Don't
worry—it's a snap to fix.
1. Open the Fastback® cover.
2. Directly in front of the heating platen is the black metal book rest; flip
this up (figure 22).
3. Now inspect the bottom of the binder. The strip will probably be
lurking somewhere around here. If it isn't, it's in the feed slot or stuck
to the platen.
4. Using the tweezers provided with your Fastback® binder, remove the
strip from the binder (figure 23).
5. If there's any glue on the platen, this is a good time to clean it (see page
35).
6. Close the cover.
The heating
F A S T B A C K ® M O D E L 1 5 x s U S E R ' S M A N U A L , R E V . C — 7 / 1 9 / 0 2
33