Using The Battery Charger To Charge The Battery - Invacare RPS350-1E Manual Del Usuario

Using the Battery Charger to Charge the
Battery
NOTE: For this procedure, refer to FIGURE 3.4.
NOTE: This procedure only applies to the RPS350‐1E.
NOTE: Invacare recommends the battery be recharged daily to
prolong battery life.
NOTE: An audible alarm will sound when battery is low.
1. Lift UP on the handle on the back of the battery.
2. Lift the battery up and away from the control box.
CAUTION
Make sure there is an audible click when
mounting battery on the battery charger.
Otherwise, injury or damage may occur.
3. Place the battery on the battery charger. Push the top of the
battery against the mounting bracket until there is an
audible click.
NOTE: The charge LED will illuminate. When charged, the LED
will stop illuminating.
NOTE: It will take approximately four hours to charge a battery that
requires a full charge.
4. Lift UP on the handle on the back of the battery.
5. Lift the battery up and away from the battery charger.
CAUTION
Make sure there is an audible click when
mounting battery on the battery charger.
Otherwise, injury or damage may occur.
6. Place the battery on the control box. Push the top of the
battery against the mounting bracket until there is an
audible click.
Part No. 1078985
Handle
STEPS 1, 2, 4 and 5)
Battery Charger
(STEP 3)
An audible "click"
will be heard when
properly installed
(STEPS 3 and 6)
FIGURE 3.4 Using the Battery Charger to Charge the
13
SECTION 3—OPERATION
Battery
Control Box
(STEP 6)
Battery
Stand Assist Patient Lift