Section 4-Lifting The Patient; Positioning The Stand Assist Lift - Invacare RPS350-1E Manual Del Usuario

SECTION 4—LIFTING THE PATIENT
SECTION 4—LIFTING THE PATIENT
DO NOT exceed the maximum weight limitation of 25 stone (350 lbs).
DO NOT attempt to any transfer without approval of the a Healthcare Professional.
ALWAYS keep hands and fingers clear of moving parts to avoid injury.
Use the sling that is recommended by the individual's doctor, nurse or medical assistant for the
comfort and safety of the individual that is being lifted.
Individuals that use the standing patient sling MUST be able to support the majority of their own
weight, otherwise injury may occur.
The legs of the stand assist lift MUST be in the maximum open position and the shifter handle locked
in place for optimum stability and safety. If the patient is in a sling and it becomes necessary to move
through a narrow passage, close the legs of the stand-up lift only as long as it takes to move through
the passage. Once the stand-up lift is through the passage, return the legs of the stand-up lift to the
maximum open position and lock the shifter handle IMMEDIATELY.
DO NOT move the patient if the patient sling is not properly connected to the attachment points on
the patient lift. Check that the patient sling is properly connected to the attachment points BEFORE
lifting the patient.
During transfer, with the patient suspended in the patient sling, DO NOT roll the base of the patient
lift over any uneven surfaces that would cause the patient lift to become unstable.
Use the steering handle on the mast assembly at all times to push or pull the Stand Assist Lift.

Positioning the Stand Assist Lift

NOTE: For this procedure, refer to FIGURE 4.1.
NOTE: Refer to General Guidelines on page 7 before proceeding and observe all warnings indicated.
NOTE: Before positioning the legs of the patient lift under a bed, make sure that the area is clear of any obstructions.
1. Ensure the legs of the Stand Assist Lift are in the
maximum open position. If not, use the shifter handle
to open the legs.
2. Position the Stand Assist Lift using the mast handle.
3. Press the DOWN button on the hand control to lower the
lift arms for easy attachment to the sling.
Stand Assist Patient Lift
WARNING
UP Button
FIGURE 4.1 Hand Control Buttons
14
DOWN Button
Hand Control
Part No. 1078985